I830 contained six parallel arrays for pipe-specific data; these
have been moved to a I830PipeRec structure instead.
I830 also contained several unused members:
unsigned int bios_version;
Bool newPipeSwitch;
Bool fakeSwitch;
int fixedPipe;
These have been removed, along with the code that set them.
The panel fitter appears to exist on the 965 hardware (at least) and
causes troubles with DVI output over SDVO when enabled. This patch
checks to see if the panel fitter is pointing at the pipe being configured
and disables it unconditionally in that case. The LVDS driver will configure
it correctly if necessary afterwards.
This should let RandR do the right thing in exposing the modes to userland.
As a side effect of getting this working, the SDVO pixel clock range code
was fixed and the mode valid tests for various outputs got extended. Also,
LVDS grew a get_modes for the fixed panel mode.
Note that we now no longer do automatic enabling of outputs at xrandr -s 0,
hotkey, or VT switch. That will be left to generic RandR code later. Also,
generic modes and user-defined modes are once again not validated into the
lists, so this is a regression there.
The get_modes should return the probed modes only. The driver should then
append to the list (for example, compatible modes listed in other outputs,
or standard VESA modes) to create the list to expose through RandR. That
isn't done yet.
This will be used by RandR, and should let us clean up some of the initial
display configuration, hopefully.
Also, analog hotplug-based detection is now enabled on G965.
This used to be called when switching back in to X. It might make some sense
to detect monitors at this time (it happens to occur at resume time, when
monitors are likely to have changed), but it should probably live in either
userland policy with RandR 1.2 or RandR 1.2 XFree86-DDX generic code.
The main change is to send SDVO commands using data passed into the send
command function, and receive responses into memory passed into the read
response function, rather than stuff things in/out through dev_priv->sdvo_regs.
This lets us use structures to represent some arguments, which results in a
nice cleanup (and 100% fewer arguments named magicN as a side effect).
Also, the mode set path is changed to not do any preferred input timing
work. We weren't doing anything legitimate with the results, since we didn't
modify the CRTC timing appropriately, so now we just stuff the CRTC timing into
both and hope for the best. This should probably be revisited later.
All the SDVO code should now be in lower case rather than StudlyCaps.
This also adjusts the I2C setup to create a bus per SDVO output we set up.
The previous setup with shared buses was failing in some circumstances, which
is probably due to the lack of refcounting in xf86i2c.c.
This is the TV connector on board for the 915GM and 945GM.
It is currently not hooked up to output initialization as it's entirely
untested. However, I think this is a reasonable starting point for getting
TV-out actually working.
This is currently disconnected, but will be used in more overhaul work.
This should be where any output limitations, such as clocks, resolution,
scaling limits, or other options, are validated. Other limitations, such as
chipset resolution limits, CRTC clock limits, etc. should be elsewhere.
Eric Anholt
Keith Packard
Keith Packard