Using pre-init computed RandR information, make reasonable
default choices for the output configuration at startup time.
Either some preferred size or a size which yields 96dpi is chosen,
from which other monitors are set to a similar size. The largest
size sets the screen size.
This needs to be extended to respect config file settings, but
those have not been defined yet.
RandR DIX code is preparing for xf86 drivers that want to allocate RandR
objects at PreInit time. This patch adapts to that change without taking
advantage of it.
Conflicts in PipeSetMode were resolved to use the keithp changes
that pushed more modesetting stuff into the per-pipe function.
Switched availablePipes to num_pipes.
Used modesetting default output configuration.
operatingDevices and MonType1/MonType2 duplicate information already stored
in the device structures. Eliminate them and replace uses with direct
references to the appropriate other data.
(cherry picked from 3ab7f96932 commit)
Also, remove setting of some other random registers that appears to have
been spammed in at the same time, and don't try to disable on the I830, before
this register existed.
DSPASURF/DSPBSURF can only take page aligned values, ignoring
the lower order bits. So, place the offset for the output
within the frame buffer in the DSPABASE/DSPBBASE registers instead.
Letting the ring buffer or other objects be allocated within the lowest
portion of memory appears to trash some memory mapping data; I'm assuming
this is the GATT table on the 965. Just marking this out of bounds for
allocation fixes this problem.
A few more register settings are needed to get CRT output working on the
965 chipset, in particular the the SDVO/UDI clock multiplier register
needed to get set to the default value (3). No, I really don't know what
this does, but it does get the CRT running at a wide range of sizes.
operatingDevices and MonType1/MonType2 duplicate information already stored
in the device structures. Eliminate them and replace uses with direct
references to the appropriate other data.
I830 contained six parallel arrays for pipe-specific data; these
have been moved to a I830PipeRec structure instead.
I830 also contained several unused members:
unsigned int bios_version;
Bool newPipeSwitch;
Bool fakeSwitch;
int fixedPipe;
These have been removed, along with the code that set them.
The panel fitter appears to exist on the 965 hardware (at least) and
causes troubles with DVI output over SDVO when enabled. This patch
checks to see if the panel fitter is pointing at the pipe being configured
and disables it unconditionally in that case. The LVDS driver will configure
it correctly if necessary afterwards.
Keith Packard
Eric Anholt
Keith Packard